Custom calibration structures and fixtures

HFE can design custom test structures on your preferred PCB substrate.
This service helps our customers to characterize PCB lauchers and connectors, and optimize bends, tapers and lines for high-speed interconnections.

Another important service is the design and realization of custom test fixtures and jigs, that allow to accurately de-embed the actual DUT S-parameters from the effect of connectors, bends and PCB lines.
The test fixtures can accommodate both matched (50 Ohm) devices and mismatched devices, if needed tapers can be included and accurately characterized.

Please inquire by e-mail describing your measurement problem, and our staff will provide a timely answer.

HFE High Frequency Engineering Sagl
6537 Grono (GR)

tel +41 918 294 380
fax +41 918 294 381